Ms. Rita 0 Posted March 1, 2009 I have the Pcut630 and working fine until now. I set my origin X0Y0, lower my blade like always and when it returns to the right side the blade goes off the vinyl by about 2 inches. H-E-L-P Share this post Link to post Share on other sites
bjbk 0 Posted March 2, 2009 that had happen to me , when i measured the vinyl it was off compared to the set up in the software Share this post Link to post Share on other sites
Cre8tiveCutter 7 Posted March 2, 2009 that had happen to me , when i measured the vinyl it was off compared to the set up in the software yeah same here. You not only have to set your workspace, but when you go to the cutter screen make sure you go to settings and see what the vinyl is set to. Took me a little while to figure this one out...lol. Renee Share this post Link to post Share on other sites
