Attaching pcut to the stand HOW?

[Cre8tiveCutter 7]

I asked this question this morning, but have yet to recieve an answer...lol. maybe no one knows  

I dont even see my post...lol. anyhow can anyone describe to me how the cutter attaches to the stand? Surely it doesnt just sit on it? I have some screws in a small bag but cant figure out where to put them???

Help!

Renee

[firemalt 10]

I'm not sure about the pcut... I didn't order a stand when I purchased mine(wish I had though).... but the refine just sits in the stand... no screws hold it down to the stand.

[Cozy 3]

Pcut attaches on the end ... the slit in the plastic hes holes into the chassis. 4 screws.

[Cre8tiveCutter 7]

thanx guys for the reply! Firemalt I cant imagine it just sitting there, I'm afraid it would just fall off with the movement of the carriage. I'm going to check it today, Cozy I did see the slits but cant figure out where the screws go! LOL!

Renee

[jhdesigns 0]

The holes are there Renee........ When we put ours together I had to lay down under the damn thing with a flashlight to line em up