randyb 1 Posted February 2, 2009 As you can tell by the several questions lately i am doing some big jobs.I have the common problem of the cutter stopping half way thru the cut.(MH721)rolland PNC1100 drivers.works great on small stuff. I cut 2 100 inch stripes and it did the first one with no trouble, then i tried 4 times to do the other one. I ran out of vinyl so while i am waiting for more i was palying with the pen.I cut 3 100 inch stripes and never missed a beat?? What you think?? Share this post Link to post Share on other sites
MikeMan 0 Posted February 2, 2009 I see you are using Refine Possible static build up from vinyl? Is stand grounded to cutter body? Share this post Link to post Share on other sites
randyb 1 Posted February 2, 2009 could be static?Since it cut the first one fine. I did ground my cutter to the stand. Any other suggestions to help with static.I do notice when the vinyl hits the carpet it picks up a ton of debris. Would wipping it down with a mist of water help or??? Share this post Link to post Share on other sites
tlzimmerman 11 Posted February 3, 2009 Dryer sheet.....roll out a little more vinyl than you need, wipe it down and roll it back up. Have also heard of people taping the sheets to the back of the machine....I haven't gone that far yet anyways. Share this post Link to post Share on other sites