RUSTYB 1 Posted January 22, 2009 Using Signblazer, I need to cut half of the image at a time and piece it together. I only have 30" vinyl and the image needs to be at 55". Share this post Link to post Share on other sites
routesmith 0 Posted January 22, 2009 click cutter and then setup and make sure your Vinyl Size is right for the size of vinyl you are cutting (I usually go a little smaller 23" with 24" vinyl just to allow for error) then click ok, the program will automatically tile it for you. You should then see the image broken up into tiles with numbers in the bottom left hand side of them and your active tile will be colored blue, after you cut the first tile, you will see a 2 pop up in the tile box in the cut window and the 2nd tile will be highlighted blue so then advance your vinyl, zero it, cut the next one. etc, etc hth, Wayne Share this post Link to post Share on other sites
cutme 5 Posted January 22, 2009 i would manually tile it before sending it to the cutter. that way i could break the image up without cutting through any of the elements of the image. that way you will never be able to tell it was tiled. bb Share this post Link to post Share on other sites
