Guest Schramm Posted December 15, 2008 Ok I am not by any means new to this stuff but from time to time I have terrible times with bad cuts or too many nodes causing the machine to quit cutting. I have cleaned this up about 5 times and tried cutting it again tonight and once again it stopped! Can someone look at it and either tell me what is wrong or make an attempt to fix it. Feel free to download it (this means everyone) but someone please fix it if you can and then repost it as I want to put it as a design in an antique mirror for a Christmas present! Thanks Rob Glass panel 1.eps Glass panel 1.eps Share this post Link to post Share on other sites
Jack Beck 2 Posted December 15, 2008 I welded all the gold pieces that could be welded. The back ground needed to be welded also. This should cut now. Jack Panel001.eps Panel001.eps Share this post Link to post Share on other sites