We just recently got an mh871mk2 plotter and got it setup. We are using oramask 810 (24") on the 34"cutter. Oir design on our laptop is 23.25"wide. We set up the origin at the very edge of the vinyl and it will start .25"from that edge (all good) however when it runs to the far left edge it runs over (by about .25 to half an inch) making the plotted cut about 1 inch bigger than our design. How do we fix this? if we make the design smaller like 11.25" it works fine on 12"vinyl. I have verified the oramadk is in fact 24"and our design is 23.25 in the software so it should fit no problem.
Is this a usb problem or is there something we are doing wrong. We selected material size 24"and selected the autofit as well with the same issues