rlucio210
-
Content Count
9 -
Joined
-
Last visited
Posts posted by rlucio210
-
-
Thanks all
-
can i ask what cut speed and pressure you guys are running?
-
how did you adjust the blade?i used a piece of scrap vinly and cit circles in it enough to where it didnt go through the backing
-
did you set the blade with skeeters directions/? did you change the blade to see if maybe you have a broken tip?blade holder is the part that holds the blade yes
it had been cutting fine butthen it started to go crazy lol i replaced the blade and still doing it
-
80 percent of the time that is too much blade exposure - about 15 percent the blade holder needs lubed or replaced - then there is the other 5 percent -when you say blade holder do you mean the silver holder the whole thing?i have only hadthe machine a few months
-
would this be the same as on a 871 - mk2 mine started doing the wavy and rippled cuts. not sure what is causing that the wheels are on the track and all
-
welcome and post the problem in the mh area of the forum - the mh people hang there a lotThank you
-
Hello all new to the forums..I have an MH-871 - MK2. having a slight issue do i post that here or in another thread? Thanks for your time
Small Font Cuts
in Vinyl Cutters
Posted
I have a MH871-MK2 that wont cut small fonts or good detail. I have set the pressure like all the down, and the cut speed to the lowest. i have tried a 45 degree and a 60 degree blade and nothing. Does anyone have any advice for me?