hotrodrichie
-
Content Count
51 -
Joined
-
Last visited
Never
Posts posted by hotrodrichie
-
-
in corel click on arrange then shaping then weld need to play with weld opt. for a while to see what it does
-
grimco inc.
-
grimco inc. is a good start
-
got any pics you care to show all so i know it takes a cnc but i want to see what is out there and what it cost for supplys
-
Eric where can a person bye stone or wood grain sign board for outdoors use I have looked all over and can not find any
-
i need a baseball all that i have tryed comes out realy bad
-
They work very well togather its all i use
-
if it cuts out your drewing and then it cuts adiag. line on it try turning of the weeding tool
-
Hay Ken i had this happen and it always did it as the cutter started to weed so i turned of weeding have not had it happen sence
-
turn on your cutter turn on your computer open signcut click on settings click on cutter settings and check your com port all so if you have PE need to start internet before you open signcut
-
when it does that pull down cutter settings and see if still conected to com port i get that when i start the sign cut program after i start the computer with a usb conection it is most likely droping the com port
-
i use corel draw x3 seams to be easey to understand for me go to corel.com can get a free trial run
-
ken when i try to send to signit X2 it works ok but it has severail diferent things you can do all of them work ok only one is not working is the stripe tool i am still in the design stage at this point not trying to cut just get job made
-
I dont know what your doing or not doing but i cut from corel X3 to sign cut X2 on a mh721 and have had no probloms eather settings is wrong or need to turn work 90*
-
Ken I think it is a plugin from signcut X2 for corel still getting the error and i realy need to get this working
-
hay banner try this site i use it a lot and it is hard for me to find it any cheper www.signoutletstore.com 36x24 white interplast sheeting $1.99
-
you can also use signit in the send to drop down from the lil rocket
-
under your bitmat command trace
-
Ya it is not chep but it is very good i think
-
Ken all works ok i only get it when i try to use the strip tool
-
Ken sorry to do this but if you get a chance look at my post in this form about signitX2 and let me know if you have any idea as what is wrong
-
computer took a dump got a new one and loaded all back on it works but every time i try to so striping i get a error says Run Time ERROR "3": Return without GoSub whats up anyone have a idea
-
hay in corel Draw X3 disk 3 clipart
-
hobbymom you have your linght and with backwards and or max linght set short 1st in inkscape and 2ed is in signcutX2
how to prepare/cleanup a file to be cut
in Corel Draw
Posted
how do you add construction points to your job i have corel x3