Hitsuga
-
Content Count
4 -
Joined
-
Last visited
Never
Posts posted by Hitsuga
-
-
-
I've got a desk lamp on my table. Seems to work well, especially with being able to adjust it.
-
On my PCUT the base under the blade that comes out to the front (The black part with the ridges on it) has a lip at the end and when the paper is feed through by the cutter it will catch in this lip and sometimes cause the paper to twist a bit.. its not a super big deal but I have to stay right at the machine while its cutting so it doesnt catch in that groove, Onces the paper is passed that spot its ok but its rather annoything. I thought about just lining up some tape over that edge so the paper wont go in there.
Black Electrical Tape. I put that in day two, and you barely notice it, it's just wide enough to cause the lip problem to go away and is easy to apply.
Pcut cutting smooth line but sometimes jagged like the knife is not spinning
in Creation PCUT Cutting Plotter Support Requests
Posted
Bumped it up to 140, worked like a charm, thanks!