I’ll try to describe my issue the best I can. I printed out my design on a large format printer. This was done through the vinyl master software so I could add the registration marks and make the cut lines. When I go to cut here is the sequence of events. I load my media into the cutter (laser point 3). I go to the cut screen and make sure ARMS is selected. I set my origin and click cut. The cutter says locating registration marks and starts finding them. It locates three of the four, but when it goes to the fourth one it stops halfway there and starts looking for it, but since it isn’t there it can’t find it and just cancels the job. Does anyone know why it wouldn’t be going all the way to the last mark? Thanks for any help you can provide.