tracienvegas
-
Content Count
7 -
Joined
-
Last visited
Posts posted by tracienvegas
-
-
OK, let me put in measurements for you. The blasé depth that shows is 1/32 of an inch.
-
Same way as always. Using the depth of a credit card for the amount of blade exposed. Is that what you meant?
- 1
-
Original setup was speed of 80 and force of 234. It cut perfect. I've been using this setting for months now. I've replaced blades before also.
This issue started during a cut.
I tried a couple different blades. I'm using 60 degree. Checked for holder and made sure no loose pieces were on the machine.
And thanks for replying and trying to help!
-
So I cut a lot of 6mil stencils. Up until yesterday, it only took one pass to cut. Now I have to do 2 passes and it still isn't completely clean.
I tried a new blade. The material is from the same pack. No settings were changed.
Is there something I need to adjust or look to see if there is interference? It's not cutting clean on vinyl either. It's almost like something is keeping it from applying the correct pressure.
-
Yes, I meant 6 mil. I'm not really worried about size. Typically they are under 8". I'm more concerned about clean cuts.
-
Will I be able to use a cutting mat to cut 6mil acetate with the SC2? I cut a lot of stencils with that material now.
Thanks.
Pressure change
in Table TITAN Series Vinyl Cutter Discussions
Posted
And I do. Especially since I cut my stencils material with a cutting mat. But my issue is why it changed in the middle of a cut with no changes being made to setup or material.
If the blade is set any lower than I have it now, it cuts across the material. this has been fine until yesterday.
No big deal. I'll figure it out. I just didn't want to have to keep double cutting. I thought someone might know why it changed during a cut I made a couple hundred times.