I'm seeing conflicting info on the Titan3 Table. Been cutting with a Cricut Explore Air2 and I feel I've outgrown it. It's not meant to "work". I am doing a lot of HTV cutting for shirts, and smaller lettering for water bottles and such. The Cricut just can't do nice clean details. It never seems to really "finish" the cut and makes for a nightmare weeding. I am branching out to Oracal 651Car lettering (back window graphics and side lettering. Problem is, the Cricut only cuts 11.5" wide x 23.5". I'm seeing the Titan3 loads 17" and cuts 15" wide, and will cut a max length of 300" which is more than I would need. Can anyone confirm I'm on the right machine? I know this little "craft cutter" is NOT the right one, but it was a good start. I've done 4 cars already, and 60+ shirts. Thanks for any advice!