blurman442003
-
Content Count
8 -
Joined
-
Last visited
Posts posted by blurman442003
-
-
That was the last model I had and it worked great for years until the motherboard went out. I never had any troubles getting it to advance after plotting either. Thanks for all your help though.
-
Is there any settings on the plotter itself that they should be set to?
-
No I am not using that software
-
Sometimes it just stops where it finishes cutting at, and other times it goes to the original starting point.
-
Yes I did, I have that box check marked but it doesn't advance still.
-
I have a Graphtec FC7000MK2-75 with Flexisign 8.1 and am trying to figure out how to get the plotter to advance and set a new origin after cutting a file. The settings on flexisign seem not to be helping.
-
Graphtec fc7000mk2-75
in Buy, Sell, and Trade
Posted
Hi, I just bought this same model a few days before you posted this. Can you help me out for a minute. I can not get this machine to advance after plotting and set a new origin.