Vanvan
Members-
Content Count
11 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout Vanvan
-
Rank
Member
-
http://www.mediafire.com/download/ecfuiyaaoduzod7/Vanvan.eps I'm use a VectorMagic and Signblazer, not option for reduce nodes
-
Secabo CV60IV = 4MB tampon memory, i'ts good? My rabbit have 4MO
-
Is there a site or one can purchase a used ? (available in Europe ) What do you think of the plotter " Secabo CV60IV " ?
-
"Have you ever been ble to cut this design before now?" No: / So my problem would come from the memory of the machine? You are on and some? I have to change my machine? : '(
-
As soon as I can I will order a series card and cables. Are you sure that it comes from that? " Have you ever successfully beens That ble to cut design before ? " I have not understood the meaning of the sentence because of the translator, if you were talking to try to do it in smaller, no I did not try .
-
Oh god ! ahahah EDIT : Nothing to report...
-
Okay , I'll invest in purchasing a serial port PCI-E . What is the stray nodes ? How do I do to fix this? Thank you ! : D
-
Only doing it when the logo on many details only ... Imagine a square with a small circle in the upper left corner ... It will start cutting in the direction of a clock hand , except that once arrived in the lower right corner , it goes back to cut the circle is in the upper left ( without raising the needle) and not completing the square ... so vinyl is good to throw , I 'm not far from 10 meters in the trash!
-
I did it and nothing changes , perhaps it was the wrong version ? Would you have a link to download it ? thank you
-
Hello , I'm sorry in advance for my bad English , I use a translator Here is my problem with SignBlazer . When I cut sticker in some detail , the program cuts across diagonally and the sticker does not realize all the cutting, so that sometimes I have to throw more than one meter of vinyl paper. Or it several times on the board cuts already made ... How to solve this problem please ? PS : My plotter is Rabbit HX 1360