bobyones 0 Posted July 2, 2019 Hello everyone. I bought a plotter pixmax720 and here is 3 days that I hurt because impossible to operate. I instal the drivers and I get a hardware called "ft232r usb uart" in the device getionnaire. I switch it to "COM1" When I run signAndCut I set the plotter to pixmax 720 or 720 B and the software sends the data but the plotter does not move. I tried with golcut and jinka settings because I read that it could work too but nothing moves. Does anyone have this plotter and if so what is the procedure? I thank you in advance . Share this post Link to post Share on other sites