acho 3 Posted November 16, 2015 Hi all, I have order for small layered design / 9x11"/. So gar I was layering such designs at the spot in process of installation but decided to test layering everything before going to customer. The test I did at home showed some issues - lots of bubles arround layer contours which does not look like they are going to disapear. I think this is due to the fact that squegee does not have good contact over ages of upper layer so the back layer can not be preesed down good /see attached photo/. Any tricks how to do pre layered install so I can save some time. Thanks Share this post Link to post Share on other sites
