Search the Community
Showing results for tags 'position'.
Found 2 results
-
alarm FC4100 pro - Y Position Alarm
LeeM posted a topic in GraphTec Cutting Plotter Support Requests
!! Please help, just collected this used plotter and when I load the media, the pen reads the media width then when returning to the right doesn’t seem to know when to stop and throws this error. Y Position Alarm Power Off im not familiar with the system so don’t know how to reset etc. many advice gratefully welcomed. thank you FullSizeRender.mov- 5 replies
-
- position
- y-position
-
(and 1 more)
Tagged with:
-
SC2 Can't set origin to the most right cutting suface
dbc posted a topic in SC Series Vinyl Cutter Discussions
I have a little over an inch of cutting surface available that I can no longer set the origin point to. This is the furthest right I can move the head using the controls. When the cutter is off I can move the head just fine all way to the right; but the minute I turn it on it moves to it current position. Using the controls I'm able to move the the head to the left and right just fine, but no further right than this. If you look a red circle; shortly after I got the cutter, I was able to set the origin further right a one time. Any ideas? ...and why is this a problem? because of this I can't cut a full 24" wide design. Now the vinyl is too close the left side beyond where the print head can go.