cowboygirl45

FINALLY GOT! Moving the cutting head clear to the right if I'm looking at the front of the cutter did the trick. I figured it would be something simple and I'd look like a goober for having to ask, but you all are awesome! Thank you sooooo much for all of the input and ideas! You got me back on track and cutting finally ! Thanks so much! Amber

Hey guys! Thanks so much for your replies! Yes, I've been setting my origin before going back on line and then I send my project to the cutter, after that it heads straight for the safety shut off. It got so late last night that I gave up on figuring it out, but I'm planning to play with it this morning to see if I can get it to behave itself . Thanks so much for your replies!!!!!!!

Okay, so here it goes. I've been on here for the past hour reading about any topic I could find regarding the emergency kill switch. I received my cutter today. It's set up, using the serial cable and Flexi Starter 8.5. Any who, I cut two test cuts, and then two simple designs and all of the sudden the cutting head has started diving for the left side of the machine and hits the kill switch. Sooooo, I turn it off, move the head off of the switch, turn it on, go to off line mode, adjust the head and hit the little middle arrow button (I'm so technical aren't I ). I then turn the cutter back onto on line mode and attempt to send my project, only to have the same stinking thing happen all over again . Any ideas you may have would be GREATLY appreciated! Later, Amber