claimer14
Members-
Content Count
29 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout claimer14
-
Rank
Member
- Birthday 01/01/1
Profile Information
-
Gender
Not Telling
-
The link doesn't work, click on it and can't find it. I am open to all options. Tripp-Lite keyspan adapter came yesterday, used disk that came with it but com port would be com9 so I had to change to com4 when it was in com4 and same result. Should I use a different driver?
-
Roland PNC 1000, I will look to see if that is available in flexi, yes make sure all three have matching values for baud
-
Yes it does do test from cutter, I will adjust baud to 4800 or 9600, it was on 9600. When I get home from work and get pictures of device manager and flexi setup. Man really, I have had this cutter for 15+ years. I know there will come time for a new one
-
So I have been using a gear head usb adapter. Change com ports to match on com 4, uninstalled driver for usb adapter and reinstalled driver, it is not communicating still. I even change baud to 2400 on cutter, program manager for usb adapter and production manager. The same vinyl cutter from 2009, I don't remember what problem was then but I changed the board on cutter. What issue was it doing in 2009 sorry can't remember and can't see what I posted. I have order Tripp-Lite keyspan adapter, it will be here tomorrow. Attached video what it does when sending it to the cutter. 20231009_164925.mp4
-
Yes, I had disc for the usb to serial adapter. It shows up in ports, yes I know to make sure com ports are matching. I think Vista or xp.
-
Alright I will change it to lower port, I switched to different port seeing if that would work. It was on port 4 before changing. Second picture is when I send it to the cutter then first picture comes after that giving write port error. It just stays at 0%, I will try using serial to serial cable. Thank you, will update once try them
-
claimer14 started following Flexi not sending to cutter
-
Hello, I have a mh1351, flexi 7.5 and 7.6, using a USB adapter. First picture is when trying to cut. Any suggestion what to check for. Thank you
-
Went to try to cut something and got this message
-
I can't seem to figure out the font and went through a lot of fonts.
-
here is what I had before asking for help and figured I could get some help from some advance members, you are right Jfought did a good job
-
thanks for trying, I will probably just go to local sign shop and it printed out
-
I was wondering if someone could help me? need help with the hair something close to same look