This thing is beating me down. I have a new Dell computer with no Serial port, thus I am forced to use the USB. I loaded SignBlazer, plugged up the USB cable to a port on the back of the machine (no hubs), I loaded the USB Driver from the blue disk, went to device manager, the usb com port said Port_#0004.Hub_#0001 on the USB Serial convertor tab, the Com port is set to COM4. Went to the cut setup tab in signblazer and set the com port to COM 4 which now says Blazer COM4 -USB Serial Port. I click cut and cut tile and it gives Cannot open the output device error initializing file
I have tried a different cable, different ports, renaming ports, unpluging replugging uninstalling and reinstalling drivers. Baud rate is 9600 on machine and software. all I can cut is a small rectangle using the pause button with the unit offline.
Ok computer wizards, somebody make me look stupid! it has to be a simple mistake, but I cannot see it
Thanks for your help