Socal

problem when using cutter second time after a first cut Freezes No comuication with Cutter and I get this in Box "Cutting tile not responding " Sending File output to cutter " Now the whole program will set there Locked . as I type this Post computer works fine but will have to reboot now and start Signcut again to cut and cut will only do one time again.same problem.

MOre on this problem when cutter second time Cutting tile not responding Sending File output to cutter Now the whole program set there as I type this Post computer works fine but will have to reboot now and start Signcut again to cut my checker board pattern ??

OK found problem Had to shut down Internet connection - so I could have CD drivers LOad OK new Problem - Software locks in Cutting Mode after I do first project have to reboot computer then can start new project but have to reboot to start again Got any Idea's

I installed driver USB but Vista dont show COM ports ?? driver installed can see in System hardware as usb converter but in Signblazer no mater what I do in setup cutter Nothing works HELP ! thx