Hi
I have had this cutter MH-MK2-28" for about 2 months. Initially, this unit worked fine. While cutting some letters (which I had cut before) today, the roller started to grab and roll up the vinyl on it while cutting. It then caused the roll to stop rolling and basically fouled up the last cut as the material did not roll any more. I live in a dry environment, so could it be static on the rollers from movement lifting the material off the backing? I guess I could try to set the rollers to predict where it might pick up a thin point of the cut, but I believe you should not have to do that as it would be trial and error, wasting material to get it set. Material being cut-Oracal 751C.
My blade set up from the start: I have the blade depth set to cut the material without cutting into the backing, cutting the material by hand before I put the blade holder on the machine. Once on the machine, I had to set the pressure up to 290 to get it to cut through the vinyl with a light scoring on the backing. I had to get that high with the pressure, as the blade was not cutting through on some lines of the cutting run while I was testing it during set it up. At 290, it just cuts through the vinyl with a light scoring of the backing.
Thank in advance for the help.
Chris