RWRacingDesigns
Members-
Content Count
10 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout RWRacingDesigns
-
Rank
Member
-
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
I’m having issues finding sign blazer. Every link I click on, says it’s no longer available -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
So after a conversation with them and a brand new cable they told me to make sure these settings are correct, and now it kind of works. When I go into the production manager and change the flow control to non the head goes down and just cuts lines back and forth. If I set it back to default XOn/XOff it does what it was doing (cutting a couple inches and locking up) and my unit is different so I can’t get into the cutter setup -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
I emailed them twice and no response. -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
I’ll check into it. I have been using LXI cloud -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
Well tried a new cable and did the same thing. Got a serial port cable, and the program says it’s starting, cutting and finished. But plotter doesn’t do anything. Double checked the drivers. Made sure it was on the correct com port. I’m at a loss. -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
Ok I didn’t even think about the printer cable. I will try that tomorrow. I appreciate all the advice. -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
Ok I didn’t even think about the printer cable. I will try that tomorrow. I appreciate all the advice. -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
I also tried to run a test without any vinyl. -
Need help, new to making decals
RWRacingDesigns replied to RWRacingDesigns's topic in General discussion
I don’t have another usb to whatever the square plug is that goes into the plotter -
RWRacingDesigns started following Need help, new to making decals
-
I’m not sure where to ask this question. I have a vinyl express r series 2. Only used it about 4 hours. It stopped mid cut and says “cannot connect to production manager”. I powered everything down. Rebooted software and tried to re cut it. It cut about 2 inches and did it again. I thought maybe it was something messed up with the file so I opened a new design, and it did it again. I haven’t found much info. What I did find was, discharge static electricity. Un install latest windows update. Make sure antivirus isn’t blocking production manager. Delete and re install drivers. Delete setup, and redo setup. I have tried everything except the cable connecting the laptop to the plotter. Any help would be greatly appreciated.