So I have the USCUTTER SC2 had it a few months and lately I’ve been having a few different issues and can’t seem to figure out how to fix them. First issue is it randomly deciding to stop the job it’s assigned to do and just starts cutting a straight line across the whole sheet of vinyl and doesn’t stop keeps going till the blade crashes into the end of the machine. The second issue is it sometimes stops and does nothing in the middle of a job never finishes. And the last issue the past week just about every time I go to send the job to the cutter it says no cutter found I have to disconnect the cutter and reconnect it just about every time. Even if I do two jobs one after another still does this. Anyone know how to fix any of these issues???
photos are from job that it randomly goes across.