So I have a client who wants some decals made. When I test cut, some of the text was ripping up when the cutter was cutting. The small text is about a half an inch tall but it is a thin font style. I’m using oracle 651 vinyl. I was wondering if I used the thin material blade if that would help. Also, what settings are you all running for pressure and speed? Thanks.
CleanCut blades arrived yesterday. WOW. In a properly organized society every cutter would come straight from the factory with these. What a difference. I went from 185 grams of force to cutting with 75g and I can cut fine detail I never dreamed of before. It's like I upgraded my cutter for $18.
Here is the same picture I posted before of Oracal 631 at 100mm/sec with the 45 blade that came with this LPII on the left. On the right is same setup with a CleanCut 60. I counted seven places where the vinyl had slightly lifted and they all sat back down with a little nudge from my fingernail. A huge Thank You to everyone who suggested these blades over and over, I'm just sorry it took me so long to make the switch!