Recommended Posts

Hi everyone 

Damsel in complete & utter DISTRESS here Trust me to have a plotter & software with hardly any troubleshooting help anywhere ...... pixmax720 cutter with easy cut pro 

To be fair, the software seems pretty decent, I can cut normally but when it comes to contour cutting it is malfunctioning when it comes to setting up registration marks....I'll set the 3rd bottom right registration mark up as the origin point then follow the on screen instructions to set the other 2 up

If I'm lucky, it will let me set them up no problem but will cut the contour too high up from the design and smaller sometimes even 

Or it starts going haywire when trying to set the other registration marks up by not allowing the cursors to control the laser properly.....

I've been trying for 4 days now, to the point where I dunno what to do next 

I've calibrated it by marking the middle of a cut "X" several times aswell as setting the X & Y to zero as advised by someone 

Nothing works

Can anyone please please help me? Could the registration marks be too small? 

Snapchat-2025411462.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now