Davis25r 0 Posted July 5, 2021 Good evening all, I made a post before about having issues with the contour cutting feature on my Titan 3 68". US Cutter was gracious enough to send me out a new motherboard (Thanks US Cutter!). I went ahead earlier today and swapped out the board. The process was straight forward (I am an engineer by day, so playing with PCBs is not daunting for me). Except for having to deal with the hot glue on all the ribbon cables and connector housings. I fired the cutter up, ran all the calibration test but ran into a big problem. I can't get the Y-Axis to move further than 613mm (24.13") without stopping. If I try and run a cut that is larger than the size, it will fault out and read "OVER SIZED PLEASE RESET". Has anyone else had issues with this before after swapping out boards on a cutter? I am wondering if I recieved a board that is programed for a 24"/28" version and not the 68" version. I will wait for US Cutter support to get back to me, but want to hear if anyone else experienced this before. Thanks! Share this post Link to post Share on other sites
slice&dice 2,450 Posted July 6, 2021 24"/28" version and not the 68" version. That's what it sounds like. Best of luck. Share this post Link to post Share on other sites
willisvalenzue 0 Posted July 26, 2021 I think it was an interesting experience 2048 cupcakes Share this post Link to post Share on other sites