Sign in to follow this  
OXWAL

PROBLEMAS DE CONFIGURACIÓN DE COPAM 2500 CON ARTCUT 2009

Recommended Posts

 

Hi everyone I have a configuration problem with my Copam 2500 ploter. I was working normally so it occurred to me to disconnect the USB cable and connect it to my laptop to work from there to reconnect to my pc I did not cut I do not know what happened I have seen tutorials everywhere and I do not get a solution, could anyone help me?

Share this post


Link to post
Share on other sites

for it to cut on your laptop you would need to install the usb emulation drivers on the laptop - when going back to the pc the port probably got changed in your device manager in whatever program you are using to an incorrect setting.

Welcome from the usa

the drivers are on the main uscutter site under support and legacy cutters 

Share this post


Link to post
Share on other sites

Any time you unplug/plug a USB device (i.e. cutter, printer, flash drive, scanner, etc.), Windows might assign a different ComPort number. Whatever computer you are wanting to use to send the file to the cutter, I suggest you check the Device Manager and see what number was assigned and make sure that it matches the number in the software that you're using.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this