chris79

Pcut cb730 / flexistarter10.5

Recommended Posts

Hello Searching for HELP PLEASE.

I have a Pcut CB730 and am using Flexistarter10.5, I used the plotter and software for a couple of years then left it sitting for around a year and have decided to get it going again. first of all I had the issue of the scent key not working but downloaded the drivers for it and have resolved that issue. Now that I want to cut a design I cant. I send the design to the production manager and get the message that it is cutting but the only thing happening on the plotter is the fan starts but no cutting action. 

I have downloaded drivers for the plotter and gone into all the recommended settings but still no luck and its sooooooooo frustrating can anyone offer any insight as to why this is not working?

Share this post


Link to post
Share on other sites

Did you go into Production manager and set the cutter up again?  Make sure you match the com port # of Flexistarter with the com port # in your computer device  manager.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now