chris79 0 Posted July 17, 2018 Hello Searching for HELP PLEASE. I have a Pcut CB730 and am using Flexistarter10.5, I used the plotter and software for a couple of years then left it sitting for around a year and have decided to get it going again. first of all I had the issue of the scent key not working but downloaded the drivers for it and have resolved that issue. Now that I want to cut a design I cant. I send the design to the production manager and get the message that it is cutting but the only thing happening on the plotter is the fan starts but no cutting action. I have downloaded drivers for the plotter and gone into all the recommended settings but still no luck and its sooooooooo frustrating can anyone offer any insight as to why this is not working? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted July 17, 2018 Did you go into Production manager and set the cutter up again? Make sure you match the com port # of Flexistarter with the com port # in your computer device manager. Share this post Link to post Share on other sites