klc 0 Posted June 23, 2018 Just installed a new motherboard for my Titan. What are the next steps to reset the carriage? Or anything to get it running again.?? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted June 23, 2018 Usually on a cutter once you replace the board you are good to go Share this post Link to post Share on other sites
klc 0 Posted June 23, 2018 When I turn the machine on, it runs the cutter head all the way to the right and just keeps thumping against the end of carriage. I plan on calling support monday, but it would be great if I could get it running now, Way be hind schedule on a 20 sign order. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted June 23, 2018 first I would double check I didn't have one of the plugs in backwards like the one to the motor that moves the carriage left and right - then guess it is up to support as I never had to take my titan apart for anything Share this post Link to post Share on other sites
darcshadow 1,626 Posted June 25, 2018 I don't know anything about that cutter, but sounds to me like an end stop sensor is not connected or not working. Share this post Link to post Share on other sites
