EXD Fargo

Overlapping Cuts

Recommended Posts

We are having an issue where the art looks fine in Flexi. Cut lines look good and where they are supposed to be. Then the Summa overlaps two letters. Does the first 3 just fine. Then it's like the knife doesn't move over far enough and cuts the 4th letter on top of the 3rd. Any suggestions? Is it a setting issue? We haven't had this issue before so we have no clue how to trouble shoot it. 

 

Thanks!

Sharon

Share this post


Link to post
Share on other sites

Did you zoom up the design real big in Flexi on wire frame and look at it real good before sending to the cutter?  Some designs may look good but really they are not.  Does your cutter have magnets at the pinch rollers, where it cannot cut past them? 

Do you have WELD unchecked?

Post some pictures.  I only know of 1 Summa owner on here. 

Share this post


Link to post
Share on other sites

Yes we checked closely in the graphic. We cut a replacement piece for the center that was overlapped and it cut just fine. Not sure if the carrier caught and didn't move or what. But the next one worked just fine. Don't have a picture because we pulled the bad piece and trashed in to replace it. 

Share this post


Link to post
Share on other sites

Weld is my friend!

Glad to hear that it all worked out. It sucks when vinyl gets wasted like that.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now