GHEENEE1 2 Posted June 4, 2017 How do you move the pinch rollers on a new Titan 2? Some of my pinch rollers aren't over the grit rollers. New from uscutter.com. Not even set up yet. Also does it need to powered on to do this? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted June 4, 2017 Just flip the lever on the back to remove pressure from them and slide them to where you need Share this post Link to post Share on other sites
skarekrow 1,842 Posted June 4, 2017 Sounds like you need to have a peek at the Manual; http://www.uscutter.com/static/PDFs/TITAN_Manual.pdf Share this post Link to post Share on other sites
GHEENEE1 2 Posted June 4, 2017 The pinch rollers did move, just very tight. New 3rd cutter didn't want to break a roller. Fyi, the man. did not help describing how tight they were. Share this post Link to post Share on other sites
steved13 19 Posted August 14, 2017 Here you go. https://support.uscutter.com/.../14000030436-what-is-the-differerce-between-the-titan...Cached at 7:40 talks about the pinch rollers being tight. I just ordered a titan 2 and was watching this video, to get ready for it's arrival and remembered this thread when I saw the part about the rollers. Thought the video might help others on the setup. Share this post Link to post Share on other sites