george234 0 Posted August 4, 2016 New to FLEXI 12. when sending cut to Graphtec FC 5100 it only cuts numbers and letters in real small font along the outer edge of the vinyl, for several feet. Flexi sends to my printer just fine, but not the cutter.. It works well thru Corel Draw and Cut master 2. The FC 5100 is suppose to cut thru Flexi, Any help.. Thanks George Share this post Link to post Share on other sites
Jburns 239 Posted August 4, 2016 That is communication settings issue thru your serial port. Mine did that when comm settings were different between the cutter and computer. Check baud rate, bit parity, X on Xoff settings in your computer, and also in device manager properties. be sure parameters match- also check what the FC5100 settings are on its menu-- it may take soem time and tests- just try and plot a circle while testing. Share this post Link to post Share on other sites
mfatty500 454 Posted August 4, 2016 Sounds like you need to change your "command" from GP-GL, to HP-GL Share this post Link to post Share on other sites