xJoey Dubsx 42 Posted July 11, 2015 So I picked up a desktop to use rather than my old slow laptop. I got Signblazer on it, and cutter is working fine, but after job it sets the cutter back at the original origin, rather then advancing past the job to next available uncut vinyl. How do I go about fixing this? MH721 with Signblazer 6.0 on Windows 8 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted July 11, 2015 can't remember exactly on signblazer but most software has an advance after plot check point you can check to it advances Share this post Link to post Share on other sites
Jburns 239 Posted July 11, 2015 Here you go - screenshot. Advance after job should take care of it:- mine is set to zero- I think it went back to origin 1 Share this post Link to post Share on other sites
pshawny 410 Posted July 11, 2015 I have mine set to 2.50. It advances the vinyl just the right amount to run a blade along the cutoff slot in the Graphtec. Share this post Link to post Share on other sites
xJoey Dubsx 42 Posted July 14, 2015 Mine has that set as well. hmm. Share this post Link to post Share on other sites