Sign in to follow this  
mr300s

Anyone have one? Or any feedback in General on Engravers

Recommended Posts

had a egx-20 for a short time  - had a chance to flip it for about 1K profit without the work and did that instead.  made 1 item and it worked pretty cool - I just needed to figure out my starting point better but was pretty easy to use

Share this post


Link to post
Share on other sites

I`m looking at a laser engraver with a 12 X 18 cutting area.

 

mark-s

  • Like 1

Share this post


Link to post
Share on other sites

had the older metza 60 I think it was - it was ok again but it is a light impact engraving.  I actually think the rotary was going to be a better deal as a lot of industrial applications still want the hard plastic engraved stuff for the machinery for durability (and some places ada) .  got a fair amount of interest in that area when i had it 

Share this post


Link to post
Share on other sites

I agree with Scott I`d go with the 350, I think you`ll be alot happier.

After doing a 25 glass etch job last week, there has got to be something

faster, time is money.

So I started looking at laser engravers, you can do so much more and faster,Remember time is money.

 

mark-s 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this