zmajzemun 0 Posted May 5, 2014 My MH1351 Refine cutter wont start cutting. Using it at Windows 7 and corel x5, usb connection, till yesterday everything was ok since the beggining. It recognized by WIndows, as soon as command sent it wont start cut and printer pannel says ''error printing''. Conncetion changed on COM/LPT as well but still wont start. I reinstalled drivers, tried to start it on Windows XP and nothing happened, same simptoms.Cutter reacts on commands from its control panel like everything is ok. Need help about his problem, anyone had similar problem? Share this post Link to post Share on other sites
outlaws 102 Posted May 5, 2014 I may be wrong but if you are using a USB connection it should be listed as port plus number. Mine list it as reading on port 21. It sounds like you have the wrong port selected in your cutter set up screen. Like I said I may be wrong but thar what it sounds like to me. Butch Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 5, 2014 did you try a different cable? Maybe the old one is damaged.. Share this post Link to post Share on other sites
zmajzemun 0 Posted May 5, 2014 @ Butch tried to change differents port,its listed on 5 and work normally, same simptoms on other ports as well. tried to change cables, old ones, new ones but nothing. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 5, 2014 you said you installed the drivers - did that include the ftdi drivers? Share this post Link to post Share on other sites
zmajzemun 0 Posted May 6, 2014 FTDI drivers installed as well. Found a link on some other topic and installed but nothing changed, same simptoms after installation. Share this post Link to post Share on other sites