Sign in to follow this  
zmajzemun

MH1351 wont start cutting

Recommended Posts

My MH1351 Refine cutter wont start cutting. Using it at Windows 7 and corel x5, usb connection, till yesterday everything was ok since the beggining. It recognized by WIndows, as soon as command sent it wont start cut and printer pannel says ''error printing''. Conncetion changed on COM/LPT as well but still wont start. I reinstalled drivers, tried to start it on Windows XP and nothing happened, same simptoms.Cutter reacts on commands from its control panel like everything is ok.

 

Need help about his problem, anyone had similar problem?

 

Share this post


Link to post
Share on other sites

I may be wrong but if you are using a USB connection it should be listed as port plus number. Mine list it as reading on port 21. It sounds like you have the wrong port selected in your cutter set up screen. Like I said I may be wrong but thar what it sounds like to me.

Butch

Share this post


Link to post
Share on other sites

@ Butch

tried to change differents port,its listed on 5 and work normally, same simptoms on other ports as well.

 

tried to change cables, old ones, new ones but nothing.

Share this post


Link to post
Share on other sites

you said you installed the drivers - did that include the ftdi drivers?

Share this post


Link to post
Share on other sites

FTDI drivers installed as well. Found a link on some other topic and installed but nothing changed, same simptoms after installation.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this