booomshakalaka 0 Posted December 11, 2012 Hello! This is my first post I have just purchased and received my first vinyl cutter, the MH871. I am excited to use it and I expect that I will be posting a lot of questions as I am learning how to use it! I have also just purchased a new laptop that has Windows 8 that I will be picking up tomorrow. I have yet to install everything just yet... but I just noticed that it indicates that it is compatable with Windows 7, but doesn't mention anything about Windows 8. Perhaps it is just because windows 8 is so new? Has anyone used it with Windows 8? Thanks Share this post Link to post Share on other sites
booomshakalaka 0 Posted December 11, 2012 I guess I should really ask if it's compatible with Sure Cuts A Lot Pro.... Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted December 11, 2012 Sure Cuts A Lot has their own support, and forum, and from what I have seen, answers questions very fast.. You might be better served, at asking them. It's their software.. They have their own techs. Share this post Link to post Share on other sites
booomshakalaka 0 Posted December 11, 2012 Thank you, is their official support within this forum in the software section? If so, I just reposted the question. I looked for an official website for them, but did not find one. Thanks again Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted December 11, 2012 Thank you, is their official support within this forum in the software section? If so, I just reposted the question. I looked for an official website for them, but did not find one. Thanks again Here is their website. http://www.craftedge.com/products/products.html Share this post Link to post Share on other sites
booomshakalaka 0 Posted December 11, 2012 Thank you Share this post Link to post Share on other sites