vinylmotivations 143 Posted May 16, 2011 Just got off the phone a little bit ago with the folks over at Cobra Ink Systems.... After long time of looking and suggestions from many here and on the T-Shirt Forums, I picked up a WF1100 from Richard. Going to be ordering some Mactac JT1958P and corresponding laminate for printing car decals etc.... Is there anything else anyone reccommends> Share this post Link to post Share on other sites
Stlouistech 2 Posted May 16, 2011 Just got off the phone a little bit ago with the folks over at Cobra Ink Systems.... After long time of looking and suggestions from many here and on the T-Shirt Forums, I picked up a WF1100 from Richard. Going to be ordering some Mactac JT1958P and corresponding laminate for printing car decals etc.... Is there anything else anyone reccommends> Good choice! I have one also. I suggest more time in a day.... Share this post Link to post Share on other sites
sashatronics 2 Posted May 24, 2011 what about a rip? wich rip you using? Share this post Link to post Share on other sites
vinylmotivations 143 Posted May 25, 2011 Well, for that, I was going to use Inkscape and just print directly from there, but for some reason inkscape is not handling color blending well and you can see, for example in a yellow/gold color you see the pixels of red in it, whereas if you save it as a jpeg, then print from another program it prints a smooth well blended color. Going to try Flexi 8 as I have that too, just not as well versed in it, and not quite sure how to add the epson as a printer unless you're just supposed to go to print and not/rip cut and use the windows driver. I am going to test this tonight to make sure its not doing any scaling. Share this post Link to post Share on other sites