wingkender 0 Posted February 1, 2011 I use out cutter for a Graphics Design class here at CHS. I initially installed the cutter on an older computer with the parallel cable. I could not get the serial or the usb cable to communicate with the cutter. Well now I have a new computer with Windows 7 and no parallel connection. I am struggling with the communicating with the cutter. I can not find any of the software that was sent with the cutter but I did go on-line and download from US Cutter what I needed. Still no communication. Then on my NEW computer the hard drive crashed and I am back a square one. Before I download anything and start again, does anybody have a link to a page or discussion about the best way to set this up in 7, newer or better drivers, or better software to use for cutting? I have installed to Adobe CS4. Thank you. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 1, 2011 The green is a rebranded Gcc cutter. here are the dirvers for that cutte from usc http://support.uscutter.com/index.php?_m=downloads&_a=view&parentcategoryid=15&pcid=0&nav=0 Share this post Link to post Share on other sites