AA09 0 Posted September 3, 2009 Can someone tell me the diff. between punched and unpunched vinyl? sorry if this is a dumb question but I'm new to vinyl and don't want to order the wrong stuff. Thanks Share this post Link to post Share on other sites
mikerob2334 2 Posted September 3, 2009 punched has holes in side for tractor fed plotters. unpunched has no holes. in your cutter is not tractor fed then you want unpunched Share this post Link to post Share on other sites
AA09 0 Posted September 3, 2009 Thank you very much for the quick response Share this post Link to post Share on other sites
midwaste 4 Posted September 3, 2009 You can use the punched in a non-tractor fed cutter, certain sizes (15 and 30") are only available in punched. Share this post Link to post Share on other sites
Guest oldthredz Posted September 3, 2009 Yes you can use punched Share this post Link to post Share on other sites
AA09 0 Posted September 3, 2009 Thanks everyone i was starting to think that they don't make 15" unpunched vinyl and they don't LOL now i can get my order out for my vinyl Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted September 3, 2009 sure, they make 15" unpunched vinyl.. most any sign shop carries it.. at least stores that sell a quantity of vinyl. Share this post Link to post Share on other sites
orbitgrfx 0 Posted May 17, 2010 Does the punch strip take away from the cutting area? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 17, 2010 yes, I just measured a 15" white punched Oracal 651 and it is under 15" total roll. and with the punch outs, it is about 14" cutting area. Share this post Link to post Share on other sites