sprinter#5 0 Posted June 26, 2009 :- Hello, My Name is John Hopkins...I have a Laserpoint 48 by UsCutter and I have flexisign pro 7.0 v2 build 0138... My computer crashed and I had to use the back up computer...this is an old computer with 533mhz pentium III processor and 288mb of ram...when I open a file to cut and I select the cut/rip button everything looks great....the production manager opens and it even sends the output to the cutter except that whatever it is cutting is not what i sent to it. I tried to load the setup again but i am not finding either the creation pcut or the uscutter in the list! Help me please i have a 1000 sticker run that is overdue by a week because my computer crashed and i am going to lose this job! Thanks John D. Hopkins if anyone is really in a good mood they can call me directly at 530-330-9140 and walk me through this.... :angel:I REALLY NEED THAT TO HAPPEN! I am supposed to have my booth open at the racetrack tomorrow and If this cutter isn't functional then that will be still more money lost that I cannot afford!!! :'( Share this post Link to post Share on other sites
Guest Posted June 29, 2009 Please download and install the USCutter driver pack which is linked at the top of the Flexi section of the forums. Make sure the software is closed when installing the driver pack. Once the pack is installed go into the production manager and add a new setup. Please select the LP 48 and the correct port. If you do not know what port you are using you can check in the Device Manager of Windows under the Ports (Com & LPT) section. This should solve your problem. Share this post Link to post Share on other sites
TeslaCoiled 1 Posted July 7, 2013 Be "nice" if the driver sw reference (mentioned on a few postings)referred to a "pinned" or sticky posting.I'm about to try:http://start.uscutter.com/laserpoint/cutter/driverfrom http://start.uscutter.com/laserpointfrom http://start.uscutter.com/If this gives me headaches, I'm moving to Linux;http://libregraphicsworld.org/blog/entry/vinyl-cutting-on-linux-the-real-dealhttps://www.google.com/search?site=&source=hp&q=linux+vinyl+cutter+software Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted July 7, 2013 all of the support info is on the USCUTTER.com website under support, including Flexi, UScutter techs rarely come here. This post is over 4 years old, was back when techs were active on the forum. http://support.uscutter.com/ Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted July 7, 2013 skeeter I think it is to spam "http://libregraphics" and hide the fact - it is posted in 5-6 other OLD post . . . just sayin Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted July 7, 2013 skeeter I think it is to spam "http://libregraphics" and hide the fact - it is posted in 5-6 other OLD post . . . just sayin Yes.... Share this post Link to post Share on other sites