So I received my machine yesterday and started cutting right away. It worked great. Everything was accurate, default settings worked fine. Today, I decided to use a different roll of vinyl that was smaller. I changed the location of the right most roller so that it would grab the vinyl. I was having problems with accuracy so I switched back to my larger roll and put the roller back where it was yesterday. I was still having problems. On smaller type (28pt Gotham) my letterforms look sloppy. Not all the lines connect. Its only off by a little tiny bit. But even beside the lines not all connecting in some areas, the stroke width of the letters just isn't consistent. I tried slowing the speed of the machine way down, I tried tightening the rollers some and then loosening some. And im still having issues. When I run the vinyl out some it moves a little tiny bit but not anymore than it did yesterday.
I did a few "test" cuts. The lines are off just slightly. I understand this may be an offset issue but I don't know what to do to fix that. But why would it work fine yesterday and not today? I am using the exact same design at the same size.