when i send the design (its a rectangle with the corners rounded) to cut it will always finish like in the picture (red circle) and the line should cut where the green line goes, i did a test cut (from the machine) and it made the square and diamond shape cut fine, i checked the design and its fine, i tried with the pen and plain paper and the drawing was correct, i checked with cutting pressure with 800g, 400g, 200g, 45g and all finish the same, i have always used redsail but tried liyu with the same end
i dont know what may cause this since the design is fine, doing a test cut is fine and everything i try ends fine, but when i start to cut the job, it ends like that.
i have the SC uscutter machine and using SignBlazer v6.0.5