Search the Community
Showing results for tags 'incomplete cuts'.
Found 2 results
-
Solved***Circles not closing, cuts slightly off, flags, tad...solved
MrJoel posted a topic in General Help
I’ve have this Laserpoint 2 since July and you can go back and look at the issues I’ve had... my offset was never quite perfect, and the overlap was causing issues sometimes leaving little .2mm slices into the design that sometimes causes a catastrophe when weeding. Then I ran some simple rectangles and found out (after $30 of Reflective was cut undersized) that my scaling was off. On a 1” square it was off.. it was .96x.97”. It doesn’t seem like much but when I recalibrated it in the software, all the other issues went away. This should be a test you run when you get your cutter or you are having problems. -
MH721-Mk2 Not Completing Cuts and Slightly Tearing The Vinyl
717 Decals posted a topic in Vinyl Cutters
My USCutter MH721-Mk2 is not completing cuts (i.e. it does not end the cut of a square where it begins the cut, it ends the cut just a small distance away from the starting point of the cut) and also seems like it is slightly tearing the vinyl instead of cutting it. I included a video with the cuts before and after weeding to show you exactly what is happening. My cut settings are in the description of the video and i have a brand new blade in it, also i am cutting Oracal 651 vinyl in case that information can help. Any advice/help would be greatly appreciated!!! Link to video: <iframe width="560" height="315" src="https://www.youtube.com/embed/bH-KKPHy_r0" frameborder="0" allowfullscreen></iframe>