Hi everyone
Damsel in complete & utter DISTRESS here Trust me to have a plotter & software with hardly any troubleshooting help anywhere ...... pixmax720 cutter with easy cut pro
To be fair, the software seems pretty decent, I can cut normally but when it comes to contour cutting it is malfunctioning when it comes to setting up registration marks....I'll set the 3rd bottom right registration mark up as the origin point then follow the on screen instructions to set the other 2 up
If I'm lucky, it will let me set them up no problem but will cut the contour too high up from the design and smaller sometimes even
Or it starts going haywire when trying to set the other registration marks up by not allowing the cursors to control the laser properly.....
I've been trying for 4 days now, to the point where I dunno what to do next
I've calibrated it by marking the middle of a cut "X" several times aswell as setting the X & Y to zero as advised by someone
Nothing works
Can anyone please please help me? Could the registration marks be too small?