-
Content Count
20 -
Joined
-
Last visited
Community Reputation
10 GoodAbout tatinc2000
-
Rank
Member
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
Did you ever get this taken care of?
-
Very nice work. I do the same but with a DIY CNC router using a spring loaded diamond drag. There is a ton of files over on the cnczone forums. Also join the facebook cnc and svg groups, lots of stuff. Also Colorcore plastic is awesome to work with, not sure if its laser-able. Picture is kinda crappy.
-
Very nice. I also make edge lit with a DIY CNC router. I use a spring loaded diamond bit to etch the glass.
-
I had issues with windows 10, drivers not working. I found a work around in VinylMaster. Here's a link to how I do it. Its fairly simple once you do it a couple times.
-
I use corel to design and export for Vinylmaster.
-
Walk away and come back at it later. I've been there, not so much in decals because I am just starting with them, I do CNC woodworking at home and metalworking at home and work. Try throwing away a 4'x8' of 2" thick stainless steel because you were off on a cut by a few thousandths.
-
I use nexus font as a font manager. You can install and uninstall them as you need them. Also you can group fonts and type samples and such. It helps me out quite a bit as I do CNC work and just started in vinyl. It doesn't need to be nexus, any font manager will work. You can have thousands of fonts on your hard drive that are not installed unless you need them.
-
Introduction and a Question of Vector Maps of Cities and Countries.
tatinc2000 replied to nffox007's topic in Introductions
Welcome to the group. -
Very cool. Looks great.
-
Side Question, How do you go about upgrading to Letter from cut? And how much was it? I would like more options than are offered with Cut.
-
VinylMaster Cut inverts trace image
tatinc2000 replied to MetalHeadGraphix's topic in VinylMaster CUT, LTR, PRO & DSR
Just import straight to VinylMaster and convert in there. I use CorelDraw X7 to VinylMaster or V-Carve Pro 8 to VinylMaster. Copy and paste does some weird stuff. Instead select all in Corel, Export as .eps from Corel, import to VinylMaster. Works great for me. I also noticed that VinylMaster doesn't do good with some .dxf files because it changes the image to short lines instead of curves. -
Welcome from Minnesota!
-
Thanks for your suggestions. I give both a try. My blade height is set so it just scratches the backing. I'll play with it more after the weekend.