-
Content Count
104 -
Joined
-
Last visited
Never
Community Reputation
0 NeutralAbout midsouthprosigns
-
Rank
Advanced Member
- Birthday 01/01/1
Profile Information
-
Gender
Not Telling
-
why not just type set the letters and draw the curves?
-
removing adhesive on plastic store front sign.
midsouthprosigns replied to ryan8281's topic in General Help
i use rapid remover from fellers its citrus based -
I have had the same proble with my 50" refine. When ever I try and cut an eight foot banner it goes crazy and runs into the other side and makes that bad noise!. So I just cut half the banner at a time. I am using a 15 or 20 foot usb cable though. I'd like to run a serial cable just need to find me a long one. Any thoughts. Is the long usb cable a bad thing?
-
Need some newbie help with car body graphic
midsouthprosigns replied to a topic in Instructional Contributions
I tuck and wrap around the edges. Make sure the edges have a clean surface or they will lift. Also I try and center the graphics the best I can. Usally that means finding lines on the car and following them. Tack things up to see how they look first on one side. When you have it the way you like take measurements and repeat on the other side. Measure Measure but if you are off one inch on one side versus the other you really cant tell its hard to see both sides at the same time. -
Silver Valley Sign Works......Kellogg Idaho
midsouthprosigns replied to svsignworks's topic in Introductions
Welcome from Memphis,TN! -
What i take to Installation site
midsouthprosigns replied to Doeboy's topic in Instructional Contributions
Man looks like you could take your plotter with you to! I use a rubber made container with all my stuff in it. I try to keep my shop tools at home. If I don't keep install tools separated I end up loosing them! or stealing from my install box! -
I know we all pic things apart on there here but the bottom line is not straight...?
-
EVERY fREAKING TIME
midsouthprosigns replied to midsouthprosigns's topic in USCutter Refine Cutting Plotter Support Requests
where do I get the ram? -
EVERY fREAKING TIME
midsouthprosigns posted a topic in USCutter Refine Cutting Plotter Support Requests
EVERY TIME i CUT A AN EIGHT FOOT BANNER IT CUTS A LINE FROM ONE CORNER TO ANOTHER ITS REALY TICKING ME OFF ANY ideas? -
I just use a hobby knife? when it gets dule stick in a new blade. I find that to work a lot faster for me. I can stick and flick a lot of stuff out like that. Buy the blades by a thousand and they are pretty darn cheap. My 2 cents.
-
Hey I got a hold of a 48" King cut. Who makes this thing and will signblazer work with it an what drivers does it us? Does it roland drivers?
-
Thank YOu!!!!!!!
-
Where can I find the drivers for this plotter!!!!! I need them bad. Thanks
-
I put all my emotions on the side lines when it comes to customers. Sometimes it just kills me but smile and make them happy even if I am burning inside! Money knows no race, creed, religion, its just all green to me. I had a political sticker on my bumper last election and I think, I know it hurt the calls I was getting so I took it off and things went back to normal. I advise all my customers to remove anything that might clash with their message.
-
cuts long lines that shouldnt be there
midsouthprosigns replied to midsouthprosigns's topic in USCutter Refine Cutting Plotter Discussion
Ok. I'll give setting up text in SBD a try and see if that makes a difference. I'm just so used to Illy. Its so much more user friendly. Thanks for ya'lls input.