gpau

Hi, I would like to install the signcut pro 2 software, I downloaded the demo, but I can't find my MH-365 cutting plotter. How can I configure it, is it compatible with this version? How do I solve it? Thank you

ok, but the uscutter MH365 is old, in the time when I bought the drivers they were. it is possible that they are no longer online? These are the new ones. I do not even know if they are still building this model. The MH365 cutter I had bought in 2012/2013.

Hello, where I can find the MH365 refine uscutter drivers. Before i format my mac the plotter mh365 also worked with mac only that I no longer find drivers who can tell me where to find them? Thank you

I have already made ​​several requests but so far no response

Fron Switzerland

but my problem is not it work with mac , what I do not understand why the roll plotter runs contrary to what should be originally . As I posted at the beginning with an attachment that shows how the roller wheel of the plotter . I can not figure out if I have to change some settings in the program or plotter . The same problem does it with windows . thank you

I do not understand how I can fix it

mh365 comes directly by using the tab is on the right . Why do you say that my mh365 is not compatible with mac I have always used with inkscape and SignCut . Since I replaced the card stops working well, this problem also creates me with windows. The card I ordered directly from uscutter giving the model of the cutter. the only difference , and this (see attached file). Configuration SignCut MH 365 with mac Yosemite (see attached file).

It is possible that the motherboard I replaced even if it is the one for uscutter mh 365 ?

But is also doing the reset does not change anything remains so .

Use SignCut for mac os

hello, who can tell me why my vinyl cutter mh365 slide backwards. Instead of pulling it from the inside to the outside makes it from the outside inwards. I do not understand why See attached photo prob cutter.pdf

Hello, you can do the stencils with plotters MH365, if you what settings should be used and what kind of material should I use. You can use the drag sheet cutter A4 thanks

Downloaded but the system tells me that it is not recognized Unable to open "SignCut" because it comes from a developer is not identified. The safety preferences allow you to install apps only from the Mac App Store and developers identified.

hello, the operating system does not recognize me OsX 10.8.2 inkscape and signcut. There are updates to make them work. thanks